MCD RACING FORUM
Site Sponsors => JoferUSA => Topic started by: EliteXpress on June 07, 2011, 05:21:24 AM
-
V4 v2 Shock Retainers
(http://i1225.photobucket.com/albums/ee391/EliteXpress/MCD%20RC%20FORUM/P6060007.jpg)
(http://i1225.photobucket.com/albums/ee391/EliteXpress/MCD%20RC%20FORUM/P6060008.jpg)
Superior quality as usual. :D
-
are they worth buying then?
-
I have not run my RRv4 with them on as of yet, but will say the fit is spot on. No flexing like the plastic ones, which should result in fewer bent $hock $haft$. :D
-
I would agree on that :D
-
Oh well... there goes the budget :unsure:
For my X4 i will not just get a set of them but also the alloy forks too, i just don't like the plastic ones. And they do help to reduce the bending and snapping... so long as you don't cartwheel it too much :lol:
-
I am waiting on a set of these arriving.
-
hmmm might have to purchase a set myself ::)
-
so do these cut down on the bending of the shock shafts?
-
Not so much the bending, but more the snapping problem that we were having. With all the flex the shafts were snapping right at the start of the threaded section of the shaft.
-
BestsMe
you're going to use in a x4,not a v4 right?
-
hmmm might have to purchase a set myself ::)
See me Sunday mate :D :D :D
-
thanks.
So in your opinion, are they worth the upgrade?
-
BestsMe
you're going to use in a x4,not a v4 right?
Joe, Yes, the ones i just ordered from you are for my X4 build.
-
thanks.
So in your opinion, are they worth the upgrade?
Personally i think so, but each to their own opinions ;)
-
no prob. I noticed one of my shafts was bent, so i spun it around so if it bends again, maybe it will bend it straight LOL.
I'll be ordering these to give a shot. Worse case they at least look good!
-
no prob. I noticed one of my shafts was bent, so i spun it around so if it bends again, maybe it will bend it straight LOL.
I have done the same thing in the past and it worked great! :lol: