Site Sponsors > JoferUSA
JOFER SERVO TRAYS AND PARTS
harryhackenbacker:
--- Quote from: Rover Man on June 04, 2011, 01:48:24 AM ---Im liking the radio trays, But is there an option for standard size servo's ?????
--- End quote ---
Dave ,the only trays I have seen are for the bigger servos ,do you run a smaller throttle/brake servo ?? or all three ,be worth doing
to Improve the steering ;) and just use one platic size reducer or fabricate one ,or even PM jofer himself ;) ;) :) :)
Rover Man:
Use standard size servo's all round. Bigger isnt always better ;)
And using the plastic adapptors means i may as well keep the plastic tray.
The only thing i thought is to make some size reducers out of carbon but would rather have the alloy tray
with standard size servo holes.
banngass:
--- Quote from: harryhackenbacker on December 24, 2010, 04:53:32 AM ---
Cheers you too :) one more part needed a tray for the top of the tank to replace the plastic one and make a solid link
from the engine bolt to the rear tower,perhaps Pink :lol: :lol: :lol:
--- End quote ---
What is status on this part? Is is out in the shops by now?
BeatsMe:
Don't think so mate, might have gone into the THB... ???
Too Hard Basket :o :lol:
harryhackenbacker:
Last time I spoke to Jofer ,he said it would need to be made in 3 parts to keep the cost down ,perhaps an updated Ultimate tank
supports system would be the answer ,but unless he has wholesale demand ,it won't happen . ;)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version